Produse pentru mepilex mollyckey (6)

Thickness range: 12-75 µm Biaxially oriented PP Optics: transparent, opaque, white, matt, glossy, metallisation on request e.g.: TI-Films, Treofan, Propafilm® Application: Food Industry, Electrical Industry, Release, Graphic Arts Industry, Pharmaceutical Industry & Healthcare, Engineering Use, Lamination, Packing Pre-treatment (surface):sealable, different pre-treatments

Pipette Tip 0,1 - 20 PP (crystal)

In the injection moulding process TPE pellets are fed into the machine through a hopper and then into a heated barrel. The heat from the barrel turns the material into a liquid resin which is then injected into a closed mould under high pressure. After allowing the molten polymer to cool, the finished part can be removed from the mould. Injection moulding is a high-volume, high tooling cost process, the advanced properties of our TPE compounds deliver short cycle times allowing parts to be produced at a rapid rate. The information below is intended as a general overview, settings may vary depending on the specific grade selected. Please CONTACT US for detailed processing information Settings Equipment Conventional injection moulding machine Compression set At least 2:1. Special screws with short sections and higher compression ratios (3:1 to 4:1) may be good at low screw speeds Shrinkage Between 1.0% and 2.5% depending on the grade, type of application and location of the gate. Moul

Kaolin M20 - 40mµ-Mahlkaolin

Cotton Applicator 150 mm Alu, Mini Head, sterile individually

Thickness range: 25-300 µm monoaxial oriented PP Optics:transparent, white Application:Electrical Industry, Label